Day 11 Back to Exams Page 1. An EtherChannel is comprised of physical, individual Ethernet, FastEthernet, GigabitEthernet, or Ten-GigabitEthernet (10Gbps) links that are bundled together into a single logical link.FalseTrueQuestion 1 of 9 2. When an EtherChannel bundle is configured as a trunk port, the trunk sends and receives PAgP frames on the highest numbered VLAN.TrueFalseQuestion 2 of 9 3. Which command displays the output below? Switch-1#Flags: S - Device is sending Slow hello. C - Device is in Consistent state. A - Device is in Auto mode. P - Device learns on physical port.Channel group 1 neighbors Partner Partner Partner Partner GroupPort Name Device ID Port Age Flags Cap.Fa0/1 Switch-2 0014.a9e5.d640 Fa0/1 2s SC 10001Fa0/2 Switch-2 0014.a9e5.d640 Fa0/2 1s SC 10001Fa0/3 Switch-2 0014.a9e5.d640 Fa0/3 15s SC 10001show pagp briefshow pagp neighborshow etherchannel summaryshow neighborQuestion 3 of 9 4. Each EtherChannel can consist of up to ____ ports.42816Question 4 of 9 5. Which switch to switch LACP mode will result in an Etherchannel being formed? Tick all that apply.Active-ActivePassive-ActivePassive-PassiveActive-PassiveQuestion 5 of 9 6. By default, PAgP packets are sent between EtherChannel-capable ports in order to negotiate the forming of an EtherChannel. These packets are sent to the destination Multicast MAC address __________, which is also the same Multicast address that is used by CDP, UDLD, VTP, and DTP.01-00-CC-CC-CC-CC01-00-0C-CC-CC-CC01-00-0C-CC-0C-CC01-00-0C-CC-CC-ACQuestion 6 of 9 7. Which switch to switch PAgP mode will result in an Etherchannel being formed? Tick all that apply.Desirable-DesirableDesirable-AutoAuto-AutoAuto-DesirableQuestion 7 of 9 8. You have configured two connected switches with the below commands. Will an Etherchannel form? Switch-1#conf tEnter configuration commands, one per line. End with CNTL/Z.Switch-1(config)#interface range fa0/1 – 3Switch-1(config-if-range)#no shutdownSwitch-1(config-if-range)#switchportSwitch-1(config-if-range)#switchport trunk encapsulation dot1qSwitch-1(config-if-range)#switchport mode trunkSwitch-1(config-if-range)#channel-group mode onCreating a port-channel interface Port-channel 1Switch-1(config-if-range)#exitSwitch-1(config)#exitNoYesQuestion 8 of 9 9. PAgP is a Cisco proprietary protocol, while LACP is part of the IEEE 802.3ad specification for creating a logical link from multiple physical links.FalseTrueQuestion 9 of 9 Loading...