Day 15 Back to Exams Page 1. ____ _____ usually occur when Ethernet cables are too long or when there are too many repeaters in the network.Frame warningsLate collisionsDuplex mismatchesInput errorsQuestion 1 of 8 2. The ______ counter increments every time an Ethernet controller wants to send data on a half-duplex connection.Carri-Sen (carrier sense) duplexcableinterface frameQuestion 2 of 8 3. On Ethernet segments, packets smaller than 64 bytes are considered ____.optimalfast-switchedruntsdamagedQuestion 3 of 8 4. Port interface speed and duplex settings can be viewed using the show _____ command.portinterfacesstatisticsspeedQuestion 4 of 8 5. With version 2, transparent mode switches will forward received VTP advertisements out of their trunk ports and act as VTP relays.TrueFalseQuestion 5 of 8 6. On Ethernet segments, packets larger than ____ bytes are considered giants.10245122561518Question 6 of 8 7. What command will produce the output below? VTP Version : running VTP2Configuration Revision : 0Maximum VLANs supported locally : 1005Number of existing VLANs : 8VTP Operating Mode : ServerVTP Domain Name : TSHOOTVTP Pruning Mode : EnabledVTP V2 Mode : EnabledVTP Traps Generation : DisabledMD5 Digest : 0x26 0x99 0xB7 0x93 0xBE 0xDA 0x76 0x9C*** MD5 digest checksum mismatch on trunk: Fa0/11 ****** MD5 digest checksum mismatch on trunk: Fa0/12 ***show status vtpshow switch statusshow vlan statusshow vtp statusQuestion 7 of 8 8. The _____ field is incremented when the switch receives frames that are smaller than 64 bytes in length. This is commonly caused by a faulty sending device.FcsErrorUnderSizeOverSizeQuestion 8 of 8 Loading...