Day 16 Back to Exams Page 1. Which are supported modes by Cisco Access Points?FlexConnectRogue detectorSnifferFlex+BridgeQuestion 1 of 19 2. In Split MAC Architecture, the GUI is accessed through the management VLAN/management port of the WLC.TrueFalseQuestion 2 of 19 3. WPA2 includes mandatory support for ____ —an AES-based encryption mode.SSLSSHCCMPTKIPQuestion 3 of 19 4. Hubs can only work at half duplex due to the limitations of the technology.TrueFalseQuestion 4 of 19 5. Cut-through switching is the lowest switching method, meaning it has the highest latency.TrueFalseQuestion 5 of 19 6. Ethernet Frame-check sequence (FCS) provides a cyclic redundancy check (CRC) on all data in the frameTrueFalseQuestion 6 of 19 7. 802.1Q supports up to ____ VLANs204810244096256Question 7 of 19 8. IP phones typically operate in the same VLAN as the data devices.TrueFalseQuestion 8 of 19 9. DTP is an open standard point-to-protocol that negotiates a common trunking mode between two switches.TrueFalseQuestion 9 of 19 10. The two DTP modes that a switch port can use, depending upon the platform, are as follows.Dynamic accessDynamic auto Dynamic trunkDynamic desirableQuestion 10 of 19 11. Your switch is in VTP client mode. How do you set it back to the default mode?Switch(config)#no vtp mode clientSwitch(config)#vtp mode transparentSwitch(config)#vtp mode defaultSwitch(config)#vtp mode server Question 11 of 19 12. In Transparent mode, the switch will forward the VTP information received out of its trunk ports, but it will not apply the changes.TrueFalseQuestion 12 of 19 13. Unlike LLDP, CDP is disabled globally on all supported interfaces, which (of course) means that you must enable CDP globally to allow a device to send CDP packets.TrueFalseQuestion 13 of 19 14. ____ are data messages used within a spanning tree topology to pass information about ports, addresses, priorities, and costs.CDPsVTPsBPDUsUpdate MessagesQuestion 14 of 19 15. Match the STP timers to the timer.Hello 20 secondsUnselect2 secondsUnselect15 secondsUnselectForward Delay 20 secondsUnselect2 secondsUnselect15 secondsUnselectMax Age 20 secondsUnselect2 secondsUnselect15 secondsUnselectQuestion 15 of 19 16. The Spanning Tree BID is an 8-byte field that is composed from a _-byte MAC address and a _-byte Bridge Priority.2/66/24/41/7Question 16 of 19 17. STP elects two types of ports that are used to forward BPDUs: the _____ Port, which points towards the Root Bridge, and the _____ Port, which points away from the Root Bridge.Master/SlaveRoot/DesignatedDesignated/RootSlave/MasterQuestion 17 of 19 18. It is the STP port that has the lowest path cost when forwarding packets from that LAN to the Root Bridge.designatedrootmasterslaveQuestion 18 of 19 19. Port Fast is a feature that is typically enabled only for a port or interface that connects to a host.TrueFalseQuestion 19 of 19 Loading...