in60days.com

Cisco CCNA in 60 Days

Header Right

Main navigation

Day 29

Back to Exams Page

1. External Border Gateway Protocol (eBGP) has an administrative distance of ?

Question 1 of 20

2. The VTP configuration revision number is included in the output of the ______ command.

Question 2 of 20

3. VTP pruning adds VLANs to the VLAN database of the local switch when local ports are a part of that VLAN.

Question 3 of 20

4. Which configuration register address setting will set the router to skip the startup configuration?

Question 4 of 20

5. Which command will reveal the VTP password?

Question 5 of 20

6. To resequence an ACL, you can use the ________ command.

Question 6 of 20

7. You only want to permit certain VLANs on a trunk link. Which command will achieve this?

Question 7 of 20

8. Which is the correct configuration command to create a NAT pool?

Question 8 of 20

9. You see the below ping output? What do the three fields represent for the figures 1/2/4?

Success rate is 100 percent, round-trip  = 1/2/4 ms

Question 9 of 20

10. If a metric for a particular route keeps getting worse, updates for that route are not accepted for a delayed period. This routing problem avoidance mechanism is known as?

Question 10 of 20

11. Network Time Protocol is designed to time-synchronize a network of machines. NTP is documented in RFC 1305 and runs over ___.

Question 11 of 20

12. The ip default-network command should only be used when ip routing is disabled on the Cisco router or switch.

Question 12 of 20

13. Which of the below is a static host route?

Question 13 of 20

14. Which command will set the loopback 0 interface as passive?

Question 14 of 20

15. For the 'show interfaces' command, the 'Giants' field indicates the number of packets that are discarded due to being larger than the maximum packet size. On Ethernet segments, packets larger than ___ bytes are considered giants.

Question 15 of 20

16. The DHCP Offer packet is sent via unicast to the requesting host.

Question 16 of 20

17. You are using port address translation and want to see which ports have been used. Which command will reveal this?

Question 17 of 20

18. Based upon the below routing table output, which route will be used first?

R       80.1.1.0/24 [120/1] via 10.1.1.2, 00:00:04, Ethernet0/0.1D       80.0.0.0/8 [90/281600] via 10.1.1.2, 00:02:02, Ethernet0/0.1O E2    80.1.0.0/16 [110/20] via 10.1.1.2, 00:00:14, Ethernet0/0.1

Question 18 of 20

19. A ping is successful only if an _______ gets to the destination and the destination is able to get an ______ back to the source of the ping within a predefined time (maximum) interval.

Question 19 of 20

20. Switch port interface speed and duplex settings can be viewed using the ______ command.

Question 20 of 20