Day 8 Back to Exams Page 1. Which command will configure an interface for a voice VLAN?SW1(config-if)#switchport trunk voice SW1(config-if)#switchport voice vlan10SW1(config-if)#switchport vlan10 voice SW1(config-vlan)#switchport voice vlan10Question 1 of 17 2. All switches must be configured with the same VTP domain name if they are to exchange VLAN information.TrueFalseQuestion 2 of 17 3. There are how many versions of VTP available?4231Question 3 of 17 4. Which command will set the default gateway for the switch?Switch(config)#ip gateway 192.168.1.1Switch(config)#default-gateway 192.168.1.1Switch(config)#ip default-gateway 192.168.1.1Switch(config-router)#ip default-gateway 192.168.1.1Question 4 of 17 5. Fragment free switching is the fastest switching method, meaning it has the lowest latency.TrueFalseQuestion 5 of 17 6. You must disable CDP on your switch if you are creating voice VLANs (for security reasons).TrueFalseQuestion 6 of 17 7. If a switch receives a frame with a broadcast destination address, then it must forward it out of all ports, apart from the port the frame was received on.TrueFalseQuestion 7 of 17 8. Switches in VTP Transparent mode will have a revision number of _ and will not increase with database changes.2103Question 8 of 17 9. Which command will set the Ethernet interface speed to 100 Mbps?Switch(config-if)#set speed 100Switch(config-if)#100Switch(config-if)#speed 100Switch(config-if)#speed 100 autoQuestion 9 of 17 10. Your switch mac address table has several mac addresses associated with one interface. What can this mean? (choose all which apply)There is a hub connected to the interfaceSwitchport security has been appliedSwitchport security hasn't been appliedThe interface is a trunk linkQuestion 10 of 17 11. 802.1Q is often referred to as frame tagging because it inserts a 32-bit header, called a “tag,” into the original frame, after the Destination Address field, without modifying other fields.TrueFalseQuestion 11 of 17 12. Fragment-free switching is a modified variety of cut-through switching. The first __ bytes of a frame are examined for any errors, and if none are detected, it will pass it on.2566432128Question 12 of 17 13. A switch port, which is defined as an access link, can be a member of only one VLAN.TrueFalseQuestion 13 of 17 14. Tick which settings on two connected switches will result in a trunk forming. (choose all which apply)Trunk - TrunkAuto - TrunkDesirable - AutoDesirable - TrunkAuto - AutoQuestion 14 of 17 15. Hubs can only work at half duplex due to the limitations of the technology.TrueFalseQuestion 15 of 17 16. Which command will set the VLAN name on your switch to Admin? Switch1(config-vlan)#ID AdminSwitch1(config-vlan)#name AdminSwitch1(config)#vlan name AdminSwitch1(config-vlan)#vlan name AdminQuestion 16 of 17 17. The show version command will reveal what information? (choose all that apply)Configuration register settingModel number for deviceBase MAC addressIOS releaseNumber of VLANs availableNumber and type of ports availableQuestion 17 of 17 Loading...
